Frequently bought together:
Description
This Rigguy CUT hub functions as the Wire Stop Hub, but has flats to make it easier to install the Wire Stops. Use the Rigguy CUT hub at center of a three way (hub and spoke) cabling system. (Conforms to ANSI A300 Standards) For all wire sizes. (1/4” to 3/8”).
The wire stop hub is the middle of a hub and spoke system for joining three trunks or leaders together. It's less damaging than triangulation because it only requires three holes instead of six. Also it requires less than half the parts (13) required in a traditional system installation (31).
Requires tapers from the Wire Stop.
Related Products
Related Products
Rigguy 4-way Hub
Rigguy
Our Price
$65.00
This Rigguy stainless steel hub allows for the connection of four leads or trunks in one central unit. For use with 1/4” to 3/8” EHS cable.
RIG389
Rigguy Wire Stop Hub
Rigguy
Our Price
$47.00
(Conforms to ANSI A300 Standards) For all wire sizes. (1/4” to 3/8”)The wire stop hub is the middle of a hub and spoke system for joining three trunks or leaders together. It's less damaging than...
RIG348
Rigguy Beveled Washer
Rigguy
Our Price
$16.00
Use this machined aluminum washer to give a flat seat for the Rigguy wire stop on angled limbs. The Rigguy beveled washer is cut at a 35% angle.
RIG387
Rigguy Wire Stop - 3/16" (ornamental)
Rigguy
Our Price
$22.00
This WIRE STOP measures only 11/16" wide by 9/16" long. It was specifically developed for use on smaller trees. (Dog woods, Bradfords, etc.)
RIG373
Finishing Cap for 1/4" & 3/16"
Rigguy
Our Price
$2.50
The Finishing Cap is not a necessary component of the Wire Stop. It does, however give a finished appearance and protection from exposed wire ends. The cap is made of UV protected vinyl.
RIG350