Hardware

Wedge-Grips by Preformed Line Products are the quickest way to terminate your cable installation in a dead end. Easy to use, quick to install, and available in sizes that cover all sizes of cable commonly used in tree cabling. The WEDGE-GRIP simply...

Wedge-Grips by Preformed Line Products are the quickest way to terminate your cable installation in a dead end. Easy to use, quick to install, and available in sizes that cover all sizes of cable commonly used in tree cabling. The WEDGE-GRIP simply...

Wedge-Grips by Preformed Line Products are the quickest way to terminate your cable installation in a dead end. Easy to use, quick to install, and available in sizes that cover all sizes of cable commonly used in tree cabling. The WEDGE-GRIP simply...

Use this machined aluminum washer to give a flat seat for the Rigguy wire stop on angled limbs. The Rigguy beveled washer is cut at a 35% angle.

The internal taper of Rigguy's wire stop fits over the middle strand of 7-strand EHS cable with the six remaining strands surrounding it. The more pressure that is applied, the deeper into the block the strand and taper are pulled. The block is made of...

The internal taper of Rigguy's wire stop fits over the middle strand of 7-strand EHS cable with the six remaining strands surrounding it. The more pressure that is applied, the deeper into the block the strand and taper are pulled. The block is made of...

(Conforms to ANSI A300 Standards) For all wire sizes. (1/4” to 3/8”)The wire stop hub is the middle of a hub and spoke system for joining three trunks or leaders together. It's less damaging than triangulation because it only requires three...

The Finishing Cap is not a necessary component of the Wire Stop. It does, however give a finished appearance and protection from exposed wire ends. The cap is made of UV protected vinyl.

The Finishing Cap is not a necessary component of the Wire Stop. It does, however give a finished appearance and protection from exposed wire ends. The cap is made of UV protected vinyl.

This WIRE STOP measures only 11/16" wide by 9/16" long. It was specifically developed for use on smaller trees. (Dog woods, Bradfords, etc.)

This Rigguy CUT hub functions as the Wire Stop Hub, but has flats to make it easier to install the Wire Stops. Use the Rigguy CUT hub at center of a three way (hub and spoke) cabling system. (Conforms to ANSI A300 Standards) For all wire sizes...

This Rigguy stainless steel hub allows for the connection of four leads or trunks in one central unit. For use with 1/4” to 3/8” EHS cable.